101
Chapter 8 Appendix
8
3A9
Upper thread hook motor overcurrent
Turn off the power, wait at least 5 seconds or more,
then turn it back on.
If the issue cannot be resolved, contact your sales
dealer.
3C1
Start/Stop switch error
The power was turned ON in the state that
the stop switch has been accidentally
pressed.
Contact your sales dealer.
3D6
CPU card error
Software installation error
3DB
System RAM insufficient capacity
CPU card
Turn off the power, wait at least 5 seconds or more,
then turn it back on.
If the issue cannot be resolved, contact your sales
dealer.
3DC
Memory device error
CPU card (Memory device)
3DD
System software installation error
CPU card (Memory device)
Contact your sales dealer.
3DE
External memory device error
USB memory
Carry out the procedure below.
• Turn off the power, wait at least 5 seconds or more,
then turn it back on.
• Replace with a different USB memory (USB flash
drive).
If the issue cannot be resolved, contact your sales
dealer.
3DF
Memory device broken
Time-based Functional limit
Turn off the power, wait at least 5 seconds or more,
then turn it back on.
If the issue cannot be resolved, contact your sales
dealer.
5B1
Design information error
Data cannot be input.
Information is not appropriate.
Check the design.
5B2
Networking error (Software)
Not connected with Network software.
Check to make sure that the LAN cable is connected
properly, and that the settings on the PC or other
devices are appropriate.
5C1
Frame origin memory incomplete
Frame origin memory is incomplete.
Carry out the procedure for memorizing the frame
origin.
"6.2.2 Memorizing the frame origin"
6B5
Communication Error
Communication Error
Contact your sales dealer.
6D1
Frame parameter file error
Frame parameter file is irregular.
B01
Formatting error
Irregular formatting!
Cannot read designs.
Use the design after copying it from the PC using a
new USB memory (USB flash drive).
B04
Empty media error
USB Memory is not inserted.
Connect the USB memory (USB flash drive) to the USB
port on the machine.
"3.2.1 Loading the design to be embroidered"
BC1
Unregistered design No.
Design No. is not found.
Copy the design from the PC to the USB memory (USB
flash drive).
BF2
Network setting error
Network setting is incorrect.
Correct the network addresses.
"6.3 Performing network settings"
Code
Message
Measure to take