Tait TB9100, Инструкция по установке и эксплуатации

Страница: 92 / 144

92 Technical Description TB9100 Installation and Operation Manual
© Tait Electronics Limited May 2006
The front panel can be easily removed from the subrack by undoing two
quick-release fasteners. Once the front panel is removed, the control panel
can also be removed from the subrack by undoing a single screw. Refer to
“Replacing Modules” on page 75 for more details.
The PMU occupies the slot at the left end of the subrack, with the PA
directly beside it. The reciter normally occupies the second slot from the
right of the subrack.
The PA is mounted vertically with the heatsink facing the center of the
subrack. This positions the cooling fins directly behind the PA fan. The
airflow separator is fitted directly beside the PA to help direct the cooling
airflow through the heatsink.
Note
The configuration for 12V base stations is the same as shown in
Figure 8.1 , but the PMU and its cooling fan are not fitted.
Figure 8.2 below shows the configuration for a typical 100 W base station.
Figure 8.2 Mechanical assembly - front of a 100W base station
b PMU f module retaining clamp
c PA g plastic guide rail
d airflow duct h subrack
e reciter i cable retaining clip
b
c
d
e
f
g
h
i