Tait TB9100, Инструкция по установке и эксплуатации

Страница: 49 / 144

TB9100 Installation and Operation Manual Installation 49
© Tait Electronics Limited May 2006
Note
If you need extra mounting security, additional mounting holes
c
are provided at the rear of the subrack for auxiliary support
brackets.
Auxiliary Support
Bracket
TBA2140 auxiliary support brackets can be fitted to the rear of the TB9100
subrack to provide additional mounting security.
Figure 4.5 shows a standard
TBA2140 bracket
b
fitted in a typical Tait Electronics cabinet
c
. If you
are not using a Tait cabinet, you may have to make your own brackets to suit
your installation.
Important
You must fit the auxiliary support brackets if you intend to
transport a cabinet fitted with a fully built-up TB9100 base
station.
We also recommend that you fit the brackets under the following
conditions:
■
when the installation is in an area prone to earthquakes
■
when third party equipment is installed hard up underneath the TB9100
base station subrack.
Optional Slide
Mounting Rails
You can also use TBA2141 slide mounting rails
b
when mounting the
TB9100 base station in a cabinet, as shown in Figure 4.6 on page 50 . These
rails will support the base station while you slide it into the cabinet.
However, you must still secure the base station to the cabinet with four M6
(0.25in) screws through the main mounting holes on the front of the
subrack, as shown in
Figure 4.4 on page 48 .
Figure 4.5 Auxiliary support bracket
c
b