Tait TB9100, Инструкция по установке и эксплуатации

Страница: 28 / 144

28 General Safety and Regulatory Information TB9100 Installation and Operation Manual
© Tait Electronics Limited May 2006
Explosive
Environments
Warning!!
Do not operate TB9100 equipment near
electrical blasting caps or in an explosive
atmosphere. Operating the equipment in these
environments is a definite safety hazard.
Proximity to RF
Transmissions
Do not operate the transmitter when someone is standing within 3 ft.
(90cm) of the antenna. Do not operate the transmitter unless you have
checked that all RF connectors are secure.
High Temperatures
Take care when handling a PMU or PA which has been operating recently.
Under extreme operating conditions (+ 140°F [+60°C] ambient air
temperature) or high duty cycles, the external surfaces of the PMU and PA
can reach temperatures of up to + 176°F (+80°C).
Equipment Safety
Installation and
Servicing Personnel
The TB9100 should be installed and serviced only by qualified personnel.
Antenna Load
Important
The PA may be damaged if the load is removed or switched
while the PA is transmitting.
To protect the PA output stage from load transients (i.e. switching or
removing the load), we recommend that you fit an isolator between the PA
and the load. Fit the isolator as close as possible to the RF output connector
on the PA. Do not connect any switching or combining equipment between
the isolator and the PA.
ESD Precautions
Important
This equipment contains devices which are susceptible to
damage from static charges. You must handle these devices
carefully and according to the procedures described in the
manufacturers’ data books.
We recommend you purchase an antistatic bench kit from a reputable
manufacturer and install and test it according to the manufacturer’s
instructions.
Figure 2.1 shows a typical antistatic bench set-up.