Tait TB9100, Инструкция по установке и эксплуатации

Страница: 73 / 144

TB9100 Installation and Operation Manual 73
© Tait Electronics Limited May 2006
Base station performs task
manager actions
unexpectedly when going
into run mode Digital input cable is not
attached, the inputs are
active low: thus if no cable
is attached the base station
reads them as all on. 1. Check the cable carrying digital inputs
2. Try to avoid Task Manager tasks that trigger
when digital inputs float high
Base station performs task
manager actions
unexpectedly and no
longer responds to digital
inputs
Lost or forgotten base
station IP address 1. Connect your PC to the 9-pin serial connector on
the back of the reciter.
2. Run a program such as HyperTerminal, Teraterm
or minicom.
3. Select the following port settings: 57600 baud, 8
bits, no parity, 1 stop bit, no flow control.
4. Press the ‘Enter’ key. A login prompt will appear
displaying the base station’s IP address.
Control panel cannot
communicate with the
dispatcher Repeat mode is disabled.
(This is currently an
inevitable consequence if
the base station has repeat
mode disabled. Disabling
repeat mode separates the
voice stream into two; the
inbound voice stream goes
to the analog line and the
outbound voice stream
goes to the transmitter.) Enable repeat mode. Use a portable for
communications with the dispatcher. A future
release will allow the choice of connecting the
microphone to the inbound or the outbound voice
stream.
Symptom Possible Cause Action