deltawaveC-P
User manual
systec Controls Mess- und Regeltechnik GmbH 67/139
www.systec-controls.de
8.7.4. Absolute thermal output measurements (absolute measurement)
with PT100
The device supports the alignment of the displayed temperature with a
reference thermometer for each PT100 used. This functionality can be
useful, for example, for heat measurements.
Example: The resistance thermometer installed in the pipe displays
80 °C. However, the resistive contact thermocouple PT100 T1 of
your deltawaveC-P displays only 78.5 °C. deltawaveC-P also
supports manual adjustment of the offset. In this case, specify a
setpoint of 80 °C. The setpoint is an absolute value and not an
offset.
Proceed as follows:
In the primary measuring window "Flow 1":
Select "SETUP" -> "CMPL
SETUP" -> CALIBRATION SETUP -> "PT100 T1"
Enter the absolute setpoint for T1. Caution: The setpoint is an absolute
value and not an offset in terms of the temperature displayed! You can
select "RESET" to delete the setpoint for PT100 T1. In this case, PT100 will
indicate the actual temperature