Symmetricom TimeProvider 500, Руководство пользователя

Страница: 41 / 174

098-00172-000 Revision A – December, 2009 TimeProvider 500 2.0 User’s Guide 41
Chapter 2 Installation & Configuration
Configuration Setup
Login: admin
Password: ***********
TP 500>
Log On Tips

admin
is the factory shipped user name and
symmadmin**
is the factory shipped
password. The
set user
command can be used to change the user name and
password. See CLI Commands , on page 77 for more information.

Logon sessions can be initiated using the serial port or remotely using Telnet. If
using Telnet, an appropriate TimeProvider 500 network address must be
established before remote sessions can be successful.

A serial session will automatically logout whenever 60 minutes elapse without
any user entry.

A remote (Telnet) session will automatically logout whenever 10 minutes elapse
without any entry.

The TimeProvider 500 simultaneously supports up to three remote logon
sessions and one serial logon session.
Configure the TimeProvider 500 IP Address
This step establishes the IP address of the TimeProvider 500. The LAN connection
from the RJ-45 connector labeled “1588” is used within the PTP domain for all
interactions with grandmaster clocks. This connection is also used for TimeProvider
500 configuration and status monitoring via Telnet.
Type
show interface config
to view a list of current PTP-related settings, which
includes the IP address, subnet mask, and gateway of the TimeProvider 500 as
shown in
Figure 2-4 .
Note : The TimeProvider 500 can be set to the factory default settings
using the CLI command,
set configuration factory
. See
set
configuration
, on page 88.