Symantec 10521148 - Network Security 7161, Руководство по внедрению

Страница: 187 / 214

179 Re-imaging and unconfiguring
Re-imaging the appliance
steps, many of which are detailed in preceding sections, you are ready to re-
image your appliance.
To prepare for re-imaging your appliance
1
Save your Symantec Network Security configuration data.
See
“Saving your configuration” on page 170.
Warning: Re-imaging your appliance will reformat the hard drive. Be sure to
save any data or configuration information to alternate media before re-
imaging.
2 Create the Imaging Server from the Recovery Software CD.
See
“Setting up a standard Imaging Server” on page 174.
3 Create a bootable compact flash.
See
“Creating a bootable compact flash” on page 171.
4 Power off the appliance.
If your appliance is on, you must power it off gracefully before beginning the
re-imaging or upgrading process. You can do this from the LCD panel or
serial console.
See
“Powering off the appliance” on page 152.
5 Insert the bootable compact flash into the appliance.
6 Connect the Imaging Server to your Symantec Network Security 7100 Series
appliance.
See
“Connecting the Imaging Server to the appliance” on page 176.
Re-imaging your appliance will re-install the original manufacturer’s software.
To re-image your appliance
1 Ensure that the appliance is powered off and the bootable compact flash
card is inserted into the CF adapter.
2 Hold down the s button on the appliance front panel while pressing the
main power switch on the back to power the appliance on.
3 Keep holding the s button while the appliance boots up. The LCD screen
displays:
Symantec v1.03
OK
4 Continue holding the s button for about 30 seconds until the LCD screen
displays:
Network Boot?