swaploader SL-212, Руководство по эксплуатации и частям

Страница: 36 / 88

Section II: Installation - Accessories
2.3.INS.ACC.51H44
INSTALLATION INSTRUCTIONS – FOLDING BUMBER ASSEMBLY
1. Review all directions and diagrams provided before starting bumper installation. Typically, a
folding bumper is needed when the rear of the container extends beyond the back of the
truck such that the
distance between the
truck bumper and
container rear exceeds
24”
(see Fig. A) . Office of
Motor Carrier Safety
(OMCS) Regulation
393.86 requires that no
bumper be located more
than 30” off the ground
when the truck is empty,
and the end of the
bumper should not be
located more than 24”
from the extreme rear of
the vehicle, including
truck bodies
(see Fig. A) .
The folding bumper will
need to be used in
conjunction with the Roller
Assembly
[Pt. No. 10H90]
and Roller Mount Brackets
Assembly
[Pt. No. 10H91]
for the container to
function properly.
2. Locate the best position
for the support bars
between the cross
members. Fabricate four
support bars out of 4” x 1”
bar cut to the length
needed to fit between the
cross members
(see Fig.
C). Fig. C shows a width
dimension of 56 1/2”. This
width can be adjusted if
interference occurs with
other items on the
container, but cannot exceed the width of the bumper tube. Weld the four bars between the
cross members.
3. Weld the front [Pt. No. 62H87] and rear [Pt. No. 62H88] brackets to the support bars. Be
sure to maintain the dimensions as indicated so that the bumper folds properly (see Fig. B &
C).
4. Weld the Pivot Arms [Pt. No. 62H84] to the Bumper Tube Weldment [Pt. No. 51H46]. Be
sure to maintain the width dimension that was used to locate the support bars in Step 2.
Figure A
Figure B
2-18