swaploader SL-212, Руководство по эксплуатации и частям

Страница: 43 / 88

Section II: Installation - Accessories
2.7.INS.ACC.LEDLB
INSTALLATION INSTRUCTIONS – LIGHT BAR ASSEMBLY
1. Review all directions and diagrams provided before starting rear light bar installation.
2. Trim truck frame to indicated dimensions (see
Fig. A). This step may have already been
performed if a bumper was previously installed.
3. Position center plate [Pt. No. 63H08] on the rear
of the main frame. Weld center plate to truck
frame
(see Fig B & Note).
4. Position stub light bar weldment [Pt. No. 51H69]
on truck frame. Stub light bar weldment should
be as high and as far back as possible on the
truck frame to avoid interference with the
bumper and fenders. It may be necessary to
modify the stub light bar weldment to avoid
interference. Drill mounting holes as required
and mount using fasteners provided
(See Fig.
C).
5.
Attach the tail light module to the stub light bar
weldments with the
fasteners provided
(see
Fig. C).
6.
Mount the identification
light bar at top center of
the center plate
[Pt. No.
63H08] using the fasteners
provided (see Fig. C).
7. Mount license lamp right of
the license plate (See Fig.
B) using the fasteners
provided (see Fig. C).
8. Mount junction box on the
back left side of center
plate
(see Fig. B), using
the fasteners provided (see Fig. C).
9. Mount all wire harnesses into the junction box. Wire harnesses must enter the junction box
through a compression fitting (based on the size of the wire harness, choose a compression
fitting with an appropriately sized grommet). Make wiring connections in junction box with
wire harness from truck cab as indicated on wiring diagram
(see schematic drawing on Pg.
2-29 ).
Figure B
Figure A
2-25