swaploader SL-212, Руководство по эксплуатации и частям

Страница: 32 / 88

Section II: Installation - Accessories
2.1.INS.ACC.52H11
INSTALLATION INSTRUCTIONS – REAR BUMBER ASSEMBLY
1. Review all directions and diagrams provided before starting bumper installation.
2. Trim truck frame to indicated dimensions (see Fig. A). These dimensions will facilitate the
mounting of the rear light assembly if it is also being mounted.
3. Measure the distance from the top of the truck frame to the ground (NOTE: This should be
performed on a level surface). Based on this measurement and the dimensions in Figure
1, the vertical channel [Pt. No. 63H94] may need to be modified in length to meet the Office
of Motor Carrier Safety (OMCS)
regulations. Regulation 393.86
requires that no bumper be located
more than 30” off the ground when
the truck is empty, and the end of the
bumper should not be located more
than 24” from the extreme rear of the
vehicle, including truck bodies
(see
Fig. B). Once the length has been
determined for the vertical channels,
weld them to the bottom of the truck
frame (see additional notes on next
page).
4. Center the bumper weldment [Pt. No.
52H12] on the vertical channels [Pt.
No. 63H94] . Position rear of bumper
from rear of the hoist as indicated by the
bumper location chart. This is crucial in order
to ensure that the container longsills do
not contact the bumper during the
dump cycle
(see Fig. A & B).
5. Weld the bumper weldment to the
vertical channels (see Fig. A & C).
Figure A
Figure B
2-14