60
SVANTEK 977W User Manual
6.3 Setting view of the logger plot - Logger View
The
Logger View
position enables the user
to change the colour of the logger curves.
Every logger curve shows the history of one
result measured in a profile, like
Peak(1)
. It
is possible to include or exclude the curve
from the logger plot, and define the colour
of this curve.
<ENT>
The view of the logger screen can be
adjusted quickly without stopping the
measurement. Highlight the function label
in the bottom left hand corner then press
the
<ENTER>
push-button and the
Logger View
list is displayed. The user can
make necessary adjustments and return to
the
Logger
view after confirmation of the
performed changes by means of the
<ENTER>
push-button.
<ENT>
6.4 Setting the display brightness and power saver - Screen Setup
The
Screen Setup
window enables the
user to set the brightness of the display and
to switch on the screen saver.
<ENT>
Brightness of the display
The
Brightness
position enables the user to set the proper brightness of the
display by means of the
◄ or ► push-buttons. The user can select 20 different
values of this parameter. The new value of the brightness level is confirmed
after each press of the
◄ or ► push-buttons.
Power saver function
The saving of the internal source of the instrument’s power can be achieved
by reducing the brightness of the screen when possible.
There are two options for the power saver function. The screen may be
switched off (
Screen off on idle
) and/or dimmed (
Dim screen on idle
).
When either of these options is set, after a delay, set by the parameters
Dim screen delay
or
Screen off delay
, from pressing any push-button the
screen is dimmed or switched off. If it has happened, the first press of any
push-button will cause the screen to switch back on again.
