Suzuki GSX-R1000 2007, Руководство по обслуживанию

Страница: 99 / 549

ENGINE 3-49
REASSEMBLY
Assemble the countershaft and driveshaft in the reverse order of
disassembly. Pay attention to the following points:
NOTE:
* Rotate the bearings by hand to inspect for smooth rotation.
Replace the bearings if there is anything unusual.
* Before installing the gears, apply engine oil to the driveshaft
and countershaft.
* When installing the oil seal, apply grease to it.
99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
NOTE:
When reassembling the transmission, attention must be given to
the locations and positions of washers and snap rings. The
cross sectional view shows the correct position of the gears,
bushings, washers and snap rings. (
3-50)
• When installing a new snap ring, pay attention to its direction.
Fit it to the side where the thrust is as shown in the illustration.
"
Thrust
Sharp edge
* Never reuse a snap ring. After a snap ring has been
removed from a shaft, it should be discarded and a
new snap ring must be installed.
* When installing a new snap ring, do not expand the
end gap larger than required to slip the snap ring
over the shaft.
* After installing a snap ring, make sure that it is com-
pletely seated in its groove and securely fitted.
When installing the gear bushing onto the counter-
shaft
and driveshaft , align the shaft oil hole
with the bushing oil hole .