Supero SuperServer 6024H-8R, Руководство пользователя

Страница: 67 / 124

Chapter 6: Advanced Chassis Setup
6-9
2. Installing/removing 5.25" drive bay component
A single 5.25" IDE drive bay is located in the front of the chassis, making
it easily accessible for installation and removal. This component is not
hot-swappable, meaning system power must be turned off before
installing and/or removing them.
To remove the drive carrier, first power down the system and then
remove the top cover of the chassis. Unscrew the retention screw at
the top center of the drive, then push the drive carrier out from the back
until you can grasp and pull it out through the front of the chassis.
Attach the component to the carrier if installing. Then reverse the drive
carrier removal procedure to install the drive, making sure you screw in
the retention screw. Replace the top cover when finished.
Figure 6-6. Removing an IDE Drive Carrier