Supero SuperServer 6024H-8R, Руководство пользователя

Страница: 38 / 124

5-4
S
UPER
S
ERVER 6024H-8R/6024H-i Manual
5-3 Connecting Cables
Now that the processors are installed, the next step is to connect the
cables to the serverboard. These include the data (ribbon) cables for the
peripherals and control panel and the power cables.
Connecting Data Cables
The ribbon cables used to transfer data from the peripheral devices have
been carefully routed in preconfigured systems to prevent them from block-
ing the flow of cooling air that moves through the system from front to back.
If you need to disconnect any of these cables, you should take care to keep
them routed as they were originally after reconnecting them (make sure the
red wires connect to the pin 1 locations). If you are configuring the sys-
tem, keep the airflow in mind when routing the cables.
The following data cables (with their serverboard connector locations noted)
should be connected. See the serverboard layout figure in this chapter for
connector locations.
z
Ultra320 LVD SCSI cable (JA1, 6024H-8R only)
z
IDE#1 cable (J5, 6024H-i only)
z
Control Panel cable (JF1, see next page)
z
CD-ROM cable (J6)
z
Floppy Drive Cable (J12)
Connecting Power Cables
The X6DH8-G/X6DHE-G has a 24-pin primary power supply connector des-
ignated "ATX_Power" (JPW1) for connection to the ATX power supply.
Connect the appropriate connector from the power supply to the "ATX
Power" connector to supply power to the serverboard. The 12V 8-pin
processor power connector at J1D1 and the 12V 4-pin power connector at
J38 must also both be connected to your power supply. See the Connec-
tor Definitions section in this chapter for power connector pin definitions.