Supero SuperServer 1025C-M3, Руководство пользователя

Страница: 38 / 110

5-2
S
UPER
S
ERVER 1025C-M3 User's Manual
Unpacking
The serverboard is shipped in antistatic packaging to avoid electrical static dis-
charge. When unpacking the board, make sure the person handling it is static
protected.
5-2 Serverboard Installation
This section explains the fi rst step of physically mounting the X7DCL-3 into the
SC113MTQ-560CB chassis. Following the steps in the order given will eliminate
the most common problems encountered in such an installation. To remove the
serverboard, follow the procedure in reverse order.
Installing to the Chassis
Release the thumbscrew at the back lip of the chassis. 1.
You can then lift the top cover from the chassis to gain full access to the 2.
inside of the server. (If already installed in a rack, you must fi rst release the
retention screws that secure the unit to the rack.
Make sure that the I/O ports on the serverboard align properly with their 3.
respective holes in the I/O shield at the back of the chassis.
Carefully mount the serverboard to the serverboard tray by aligning the board 4.
holes with the raised metal standoffs that are visible in the chassis.
Insert screws into all the mounting holes on your serverboard that line up with 5.
the standoffs and tighten until snug (if you screw them in too tight, you might
strip the threads).
Note: Metal screws provide an electrical contact to the serverboard ground to
provide a continuous ground for the system.