Supero SuperServer 1025C-M3, Руководство пользователя

Страница: 26 / 110

2-10
S
UPER
S
ERVER 1025C-M3 Manual
2-5 Checking the Serverboard Setup
After you install the 1025C-M3 in the rack, you will need to open the unit to make
sure the serverboard is properly installed and all the connections have been
made.
Removing the Chassis Cover (Figure 2-5)
Grasp the two handles on either side and pull the unit straight out until it 1.
locks (you will hear a "click").
Remove the screws securing the top cover to the chssis. 2.
Slide the cover toward the rear of the chassis. 3.
Lift the cover off the chassis. 4.
Checking the Components
You should have one or two processors already installed into the serverboard. 1.
Each processor needs its own heatsink. See Chapter 5 for instructions on
processor and heatsink installation.
Figure 2-5: Removing the Chassis Cover
4
3