FORM NO. 660769 REV. C PAGE 46
Trimming the Crossbeam
1. Cut same distance off of either end of crossbeam.
2. Using a 13/32” drill bit drill new holes in crossbeam end as shown.
Trimming the Wind guide pipe
1. Cut same distance off either end of wind guide pipe.
5. Place black plastic cap back in tube. Using a 5/32” (.156) drill bit, drill three pilot
holes into black plastic cap.
6. Using existing screws, secure black plastic cap back onto tube.
Содержание SWIFTSHIELD A Series
Страница 5: ...FORM NO 660769 REV C PAGE 5 SwiftShield Overview Continued Lines shown disconnected...
Страница 8: ...FORM NO 660769 REV C PAGE 8 1 B Remove The contents of the Power Pack box Pump RC Unit Battery...
Страница 12: ...FORM NO 660769 REV C PAGE 12 1 F Drill Manifold Mounting Holes Location Of Mounting Holes...
Страница 13: ...FORM NO 660769 REV C PAGE 13 1 G Mounting the Pump Note Mount pump using the holes on the left...
