Sun Microsystems X3-3L, Руководство по установке

Страница: 28 / 80

18 Sun Server X3-2L Installation Guide for Windows Operating Systems • April 2014
▼
Verify the BIOS Factory Defaults
Note – If the server is newly installed and this is the first time that an operating
system has been installed, then BIOS is probably configured to its default settings
and you do not have to perform this task.
In the BIOS Setup Utility, you can set optimal defaults, as well as view and edit BIOS
settings as needed. Any changes you make in the BIOS Setup Utility (through F2) are
permanent until the next time you change them.
In addition to using F2 to view or edit the system’s BIOS settings, you can use F8
during the BIOS start-up to specify a temporary boot device. If you use F8 to set a
temporary boot device, this change is only in effect for the current system boot. The
permanent boot device specified through F2 will be in effect after booting from the
temporary boot device.
Before you begin, ensure that the following requirements are met:
■
The server is equipped with a hard disk drive (HDD) or solid state drive (SDD).
■
The HDD or SDD is properly installed in the server. For instructions, see the Sun
Server X3-2L Service Manual, “Servicing Storage Drives and Rear Drives (CRU)” on
page 45 .
■
A console connection is established to the server. For details, see “Selecting the
Console Display Option” on page 4 .
1. Reset or power on the server.
For example:
■
From the local server , press the Power button (approximately 1 second) on the
front panel of the server to power off the server, and then press the Power
button again to power on the server.
■
From the Oracle ILOM web interface , click Host Management > Power
Control and select Reset from the Select Action list box.
■
From the Oracle ILOM CLI on the server SP , type the following command
from the prompt:
-> reset /System
When prompted, enter
y
to confirm:
Are you sure you want to reset /System (y/n)? y
Performing hard reset on /System
The BIOS screen appears.