Sun Microsystems SWB 300, Руководство оператора

Страница: 90 / 128

90
7-2
7-1
Trouble shooting
7.1 System messages
The wheel balancer can show messa ges to the
operator. These may be error related (E-codes) or
warnings (H-codes). The codes will be described in
the following chapters.
Whenever a code appears:
•
make a note of it;
•
look up the code in the list. If the code is not
described, call service team;
•
perform the steps described.
In special cases, or if the need arises, some operating
modes or states can be changed by entering the
appropriate codes (C Codes)
.
7.1.1 C Codes
Selecting and changing a code.
Example for code C0 (Fig. 7-1)
— Press and hold down
together
the
“ STAR ” (7) and
“ FINE ” (8) keys for 5 seconds
.
The C codes selection condition appears ( Fig. 7-2 ).
— Press one of the “ + ” (4) or “ - ” (6) keys until the
readout shows the desired code number (e.g.: C
0).
— Press the ENTER key (5) to acquire the selection.
The right number readout shows the current state, e.
g.
: “ 0 ” which in this case means switched off.
If the desired state is already on the readout:
— Press the STOP key ( 10, Fig. 7-1 ) once to return to
C codes selection (Fig. 7-2) , and a second time to
defi nitively exit and return to the operating mode.
If the desired state is not that shown by the readout,
but needs selecting, proceed as follows:
— Press one of the “ + ” or “ - ” keys until the right
readout shows the desired condition (e.g. : “ 0 ”).
Now two options are possible:
Option 1
— Press the ENTER key to acquire the selection.
— Press the STOP key to return to the operating
mode.
The operating mode change is complete and is saved
until a new setting is entered. When the machine is
switched off the settings are not deleted, and at each
subsequent start up they appear as previously set up
until changed again.
4 5 6 7 8
10