122
iii-1
iii-2
iii-3
iii-3a
1
2
3
4
5
6
7
8
6
Installation
iii Installation procedures
Wheel balancer:
Refer to the drawing in i for correct wheel balancer
positioning. If the wheel balancer needs securing,
we recommend fi xing elements with a diameter of
8 mm, quality 8.8 or higher.
Supports for Accessories:
•
Unpack the 4 threaded accessory support studs
and the support plates.
•
Refer to
Figure iii-1
. Fit the 4 threaded accessory
support studs and the plates.
Stub shaft:
(except for “P” machines)
•
Clean the stub shaft and the hole in the main shaft.
•
Refer to
Figure iii-2
. Position the stub shaft.
•
Use a pin for screwing.
Clamping devices:
•
Put the clamping devices on the accessory studs.
Wheel guard:
•
Refer to
Figure iii-3
.
The wheel guard
infl uences the following modes
of operation:
—
The measuring run is started by closing the wheel
guard.
—
The wheel is braked on lifting the wheel guard
during a measuring run (code C 5).
Fig.
iii-3
—
Slide the wheel guard (
1
) on the arbor (
2
) and raise
it until the fastening holes of wheel guard and wheel
guard arbor coincide.
—
Insert the M10 setscrew (
3
) with washer (
4
) from
below, and tighten the hexagon nut (
5
) and washer.
Fig.
iii-3a
(only for machines with Sonar)
—
Connect the plug of the cable (
6
) with the connector
of the machine (
7
) which is projecting out of the
opening in the machine cabinet.
—
Place the plugs loosely inside the machine through
the hole in the machine cabinet.
Caution
:
Since the cable is moved during opening and closing
the wheel guard, it must be passed in the band (
8, Fig.
iii-3a
) under the wheel guard.
Содержание SWB 300
Страница 116: ...116 Blank Page ...
Страница 126: ...126 Blank Page ...
Страница 127: ...127 Blank Page ...
