Sun Microsystems SunSwift SPARCserver 1000, Руководство по обслуживанию

Страница: 139 / 218

System Board and Component Replacement 10-9
10
Figure 10-5 Installing SuperSPARC Module B
10.3.2 Replacing a SuperSPARC Module
1. Unlock standoffs for the chosen location if they are not already unlocked.
Pull up the tip insert of a standoff to unlock it. See Figure 10-3.
2. Take the module out of the protective packaging and inspect the
connector for bent pins.
3. Place the module on the standoffs and align the module connector with
the system board socket. For SuperSPARC Module B, slide the back panel
end (the side opposite the connector) into place under the lip of the back
panel filler panel, then align the connector with the socket.
Ensure holes in the board align with filler panel pins. See Figure 10-5.
Caution – Ensure the heat sink does not catch on the lip of the system board
back panel during installation. If it does, the board will not seat properly in the
backplane.
!