Sun Microsystems SunSwift SPARCserver 1000, Руководство по обслуживанию

Страница: 96 / 218

7-6 SPARCserver 1000 System Service Manual—June 1996
7
b. Press down on the popout at the small dot.
This action rocks the popout on a hinge-point, unlatching it.
c. Slide the popout back, away from the dots and lift it free as shown in
Figure 7-5. Set the popout aside.
2. Repeat step 1 to remove the remaining three popouts from the top panel.
Figure 7-5 Removing the Popouts from the Top Panel
▼
Remove the Top Panel
3. Remove the panel. Use the steps below and refer to Figure 7-6:
a. Place your fingers under the panel rear lip and lift.
Lift with enough force to bow the panel rear up at the center. This action
causes three small raised features on the panel underside to clear cutouts
in the chassis sheet metal.
b. While lifting the panel rear, tap the front with your hand to slide the
panel rearward.
Slide the panel a few inches only. This is enough to disengage it from the
chassis.
Note – If necessary, slide your lifting hand side-to-side under the rear lip while
tapping the front to free each of the three raised areas on the panel underside
of sheet metal cutouts beneath.