Sun Microsystems SunSwift SPARCserver 1000, Руководство по обслуживанию

Страница: 88 / 218

6-8 SPARCserver 1000 System Service Manual—June 1996
6
6.3 Boot Messages
Use boot software messages to verify all options are installed and recognized
by the system. After POST completes self-test, a message like the following will
appear on your screen. The message lists hardware components detected by
the system.
Note – This screen display is an example only. The actual message displayed
on the screen will depend on the software running on your system.
Boot the system using the appropriate procedure for your operating system.
After boot, check the status of the system by inspecting system status LEDs on
the front panel. See Table 6-1 and Figure 6-5.
Ideally, after the self-tests finish, both left and right LEDs should be on. The
less than ideal condition is if all LEDs are on (system needs service, but is able
to run). The worst conditions are if the left and middle LEDs are on (system
cannot boot), or if none of the LEDs is on.
<<<< SPARCserver 1000 POST V4.1 >>>>
... (various test messages) ...
SPARCserver 1000 Series No Keyboard
ROM Rev. -.-, --- MB Memory installed, Serial #---.
Ethernet address -:-:--:-:--:--, Host ID: ------.
Table 6-1 Front Panel LED System Status
Location Condition
Left LED On — DC power supply is receiving AC current
Middle LED On — (first 60 seconds of AC power) self tests are running
Off — (after self tests end) no hardware failures detected
On — (after self tests end) hardware failure was detected
Right LED Off — (first 60 seconds of AC power) self tests are running
On — (after self tests end) system is running
Off — (after self tests end) system cannot run; repair is needed