Sun Microsystems Sun Blade 100, Руководство по обслуживанию

Страница: 150 / 222

8-18 Sun Blade 100 Service Manual • October 2000
1. Using needle-nosed pliers, set the Flash PROM Jumpers, JP1 and JP2.
Flash PROM jumpers JP1 and JP2 are used for reprogramming specific code blocks
and remote programming of the flash PROM.
FIGURE 8-8
illustrates the default JP1/
JP2 jumper settings for the flash PROM.
TABLE 8-2
identifies the flash PROM jumper
settings. The default shunt settings of jumpers JP1 and JP2 are 1-2. Placing the shunt
on pins 2 and 3 enables the flash PROM for reprogramming.
FIGURE 8-8
JP1/JP2 Jumper Settings for the Flash PROM
2. Replace the DIMMs.
See Section 8.3.2 “Replacing a DIMM” on page 8-10.
3. Replace the NVRAM/TOD with carrier.
See Section 8.2.2 “Replacing the NVRAM/TOD” on page 8-7.
4. If you removed the CPU or will install a new CPU, see Section 8.1.2 “Replacing
the CPU” on page 8-3.
5. Carefully, slide the motherboard tray into the chassis.
6. Position the motherboard connector against the riser board connector and ensure
that the connector keys are properly aligned.
a. Push the motherboard ejection lever toward the chassis to lock the
motherboard into the riser board connector.
b. Verify that the motherboard is firmly locked into the riser board by gently
pressing the motherboard tray into the riser board connector.
TABLE 8-2
Flash PROM Jumper Settings
Jumper Pins 1-2 Select Pins 2-3 Select Default Jumper on Pins
JP1 To onboard PROM (default) To ROMBO 1-2
JP2 Disable Enable 1-2
1
JP1
JP2
2
3
1
2
3