Subaru WRX 2018, Руководство пользователя

Страница: 362 / 572

Starting and operating/Starting and stopping the engine
controlled throttle
’
s self-diagnosis
function. To overcome it, keep the
ignition switch in the
“
ON
”
position
for approximately 10 seconds before
starting the engine.
&
Models without push-button
start systems
!
Starting engine
CAUTION
Do not operate the starter motor
continuously for more than 10 sec-
onds. If the engine fails to start after
operating the starter for 5 to 10
seconds, wait for 10 seconds or
more before trying again.
NOTE
Do not shift the shift lever/select lever
while the starter is cranking.
!
MT models
1. Apply the parking brake.
2. Turn off unnecessary lights and ac-
cessories.
3. Depress the clutch pedal to the floor
and shift the shift lever into neutral. Hold
the clutch pedal to the floor while starting
the engine.
The starter motor will only operate when
the clutch pedal is depressed fully to the
floor.
4. Turn the ignition switch to the
“
ON
”
position and check the operation of the
warning and indicator lights. Refer to
“
Warning and indicator lights
” F
3-13.
5. Turn the ignition switch to the
“
START
”
position without depressing the accelera-
tor pedal. Release the key immediately
after the engine has started.
If the engine does not start, perform the
procedure described in
“
If the engine does
not start
” F
7-11.
6. Confirm that all warning and indicator
lights have turned off after the engine has
started.
!
CVT models
1. Apply the parking brake.
2. Turn off unnecessary lights and ac-
cessories.
3. Shift the select lever to the
“
P
”
or
“
N
”
position (preferably the
“
P
”
position).
The starter motor will only operate when
the select lever is at the
“
P
”
or
“
N
”
position.
4. Turn the ignition switch to the
“
ON
”
position and check the operation of the
warning and indicator lights. Refer to
“
Warning and indicator lights
” F
3-13.
5. Turn the ignition switch to the
“
START
”
position without depressing the accelera-
tor pedal. Release the key immediately
after the engine has started.
If the engine does not start, perform the
procedure described in
“
If the engine does
not start
” F
7-11.
6. Confirm that all warning and indicator
lights have turned off after the engine has
started.
While the engine is warming up, make
sure that the select lever is at the
“
P
”
or
“
N
”
position and that the parking brake is
applied.
CAUTION
If you restart the engine while the
vehicle is moving, shift the select
lever into the
“
N
”
position. Do not
attempt to place the select lever of a
moving vehicle into the
“
P
”
posi-
tion.
7-10