Subaru WRX 2018, Руководство пользователя

Страница: 218 / 572

Instruments and controls/Mirrors
1) Status Indicators
8. If status indicator arrows appear next
to the indicator light, please refer to
“
Garage Door Two-Way Communication
”
F
3-81.
In the event that there are still program-
ming difficulties or questions, additional
HomeLink information and programming
videos can be found at
www.HomeLink.com and
www.youtube.com/HomeLinkGentex. For
Genie and Sommer garage door openers
please go directly to the HomeLink web-
site.
!
Gate Operator / Canadian Pro-
gramming
Canadian radio-frequency laws require
transmitter remote signals to
“
time-out
”
(or quit) after several seconds of transmis-
sion, which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian
law, some U.S. gate operators are de-
signed to
“
time-out
”
in the same manner.
The indicator LED on the hand-held
remote will go off when the device times
out, indicating that it has finished transmit-
ting.
If you live in Canada or you are having
difficulties programming a gate operator or
garage door opener by using the program-
ming procedures, replace
“
Programming a
New HomeLink Button
”
step 3 with the
following:
While the HomeLink indicator light is
flashing orange, press and release (
“
cy-
cle
”
) your device
’
s hand-held remote
every two seconds until the HomeLink
indicator light changes from orange to
green. You may now release the hand-
held remote button.
NOTE
If programming a garage door opener
or gate operator, it is advised to unplug
the device during the
“
cycling
”
pro-
cess to prevent possible overheating.
Proceed with
“
Programming a New
HomeLink Button
”
step 4 to complete.
!
Using HomeLink
To operate, simply press and release the
programmed HomeLink button. Activation
will now occur for the trained device (i.e.
garage door opener, gate operator, secur-
ity system, entry door lock, home/office
lighting, etc.). For convenience, the hand-
held remote of the device may also be
used at any time.
!
Erasing HomeLink Buttons
To erase programming from the three
buttons (individual buttons cannot be
erased but can be
“
reprogrammed
”
as
outlined below), follow the step noted:
Press and hold the two outer HomeLink
buttons for at least 10 seconds. The LED
indicator will change from continuously lit
to rapidly flashing. Release both buttons.
Do not hold for longer than 20 seconds.
HomeLink is now ready to be programmed
at any time beginning with
“
Programming
a New HomeLink Button
”
- step 1.
3-80