Subaru WRX 2018, Руководство пользователя

Страница: 106 / 572

Keys and doors/Keyless access with push
–
button start system
depending on the location of the
access key fob.
.
The access key fob contains
electronic components. Observe
the following precautions to pre-
vent malfunctions or battery dis-
charge.
–
It is recommended that the
battery be replaced by a
SUBARU dealer to avoid the
damage at the time of replace-
ment.
–
Do not get the access key fob
wet. If the access key fob gets
wet, wipe it off immediately
and let it dry completely.
–
Do not apply strong impacts
to the access key fob.
–
Never leave the access key
fob in direct sunlight or any-
where that may become hot,
such as on the dashboard.
–
Do not wash the access key
fob in an ultrasonic washer.
–
Do not leave the access key
fob in humid or dusty loca-
tions, or near personal com-
puters or home electric appli-
ances.
–
Keep the access key fob away
from magnetic sources.
–
Do not leave the access key
fob near a battery charger or
any electrical accessories.
–
Do not apply metallic window
tint or attach metallic objects
to the windows.
–
Do not fit non genuine acces-
sories or parts.
NOTE
After the vehicle battery is discharged
or replaced, initialization of the steering
lock system may be required to start
the engine. In this case, perform the
following procedure to initialize the
steering lock.
1) Turn the push-button ignition
switch to the
“
OFF
”
position. For de-
tails, refer to
“
Switching power status
”
F
3-7.
2) Open and close the driver
’
s door.
3) Wait for approximately 10 seconds.
When the steering is locked, the initi-
alization is completed.
!
Regarding setting
NOTE
.
You can change the operational/
non-operational setting for the keyless
access function. For the setting proce-
dure, refer to
“
Disabling keyless ac-
cess function
” F
2-15. The setting can
also be changed by a SUBARU dealer.
For more details, contact a SUBARU
dealer.
.
For detailed information about the
operation method for the push-button
ignition switch while the keyless ac-
cess function is switched to the non-
operational mode, refer to
“
Access key
fob
–
if access key fob does not
operate properly
” F
9-17.
!
Radio waves used for the keyless
access with push-button start sys-
tem
The keyless access with push-button start
system uses radio waves of 134 kHz, in
addition to the radio waves used for the
remote keyless entry system. The radio
waves are periodically output from the
antennas installed on the vehicle as
shown in the following illustration.
2-10