Subaru 2011 Tribeca, Руководство пользователя

Страница: 501 / 580

Black plate (348,1)
北 米
Model "A3160BE-C" EDITED: 2010/ 11/ 19
11-12
Maintenance and service
1) Fill up to here
5. Slowly pour the coolant and fill up to
just below the filler neck, allowing enough
room to add genuine SUBARU cooling
system conditioner in the radiator. Add
genuine SUBARU cooling system condi-
tioner until the coolant level reaches the
filler neck. Do not pour the coolant too
quickly, as this may lead to insufficient air
bleeding and trapped air in the system.
NOTE
For guidelines on coolant quantity
(including the coolant in the reservoir
tank), refer to
“
Engine coolant
” F
12-7.
1)
“
FULL
”
level mark
6. Pour the coolant and fill to the reser-
voir tank
’
s
“
FULL
”
level mark.
7. Put the radiator cap back on and
tighten firmly. At this time, make sure that
the rubber gasket in the radiator cap is
correctly in place.
8. Start and race the engine at 2,000 to
3,000 rpm for 5 to 6 times within 40
seconds.
9. Stop the engine and wait until the
coolant cools down (122 to 140
8
F [50 to
60
8
C]). If there is any loss of coolant, add
coolant to the radiator
’
s filler neck and to
the reserve tank
’
s
“
FULL
”
level.
10. Put the radiator cap and reservoir cap
back on and tighten firmly.