Subaru 2008 OUTBACK, Руководство пользователя

Страница: 270 / 444

Black plate (277,1)
北 米
Model "A2440BE-B" EDITED: 2007/ 5/ 7
moving.
.
If the temperature of the automatic
transmission fluid becomes too high,
the
“
AT OIL TEMP
”
warning light will
come on. Immediately stop the vehicle
in a safe place and let the engine idle
until the warning light goes off.
&
Maximum speeds
WARNING
When down shifting, ensure that the
vehicle is not travelling at a speed
exceeding the Maximum Allowable
Speed for the gear which is about to
be selected. Failure to observe this
precaution can lead to engine over-
revving and this in turn can result in
engine damage.
In addition, sudden application of
engine braking caused by down
shifting when the vehicle is travel-
ling on a slippery surface can lead
to wheel locking; as a consequence,
control of the vehicle may be lost
and the risk of an accident in-
creased.
The following tables show the maximum
speeds that are possible with each differ-
ent gear.
When down shifting, it is important to
confirm that the current vehicle speed is
not in excess of the Maximum Allowable
Speed of the gear which is about to be
selected.
Legacy
mph (km/h)
Position
2.5-liter turbo
models
3.0-liter models
1 25 (40) 27 (43)
2 53 (85) 51 (82)
3 85 (137) 84 (135)
OUTBACK
mph (km/h)
Position
2.5-liter turbo
models
3.0-liter models
1 25 (40) 28 (44)
2 53 (85) 52 (84)
3 86 (138) 87 (139)
Never exceed posted speed limits.
&
Driving tips
.
On a road surface where there is a risk
of wheelspin (for example, a snow- or
gravel-covered road), you can pull away
from a standstill safely and easily by first
selecting the 2nd gear of the manual
mode.
.
Always apply the foot or parking brake
when the vehicle is stopped in the
“
D
”
or
“
R
”
position.
.
Always set the parking brake when
parking your vehicle. Do not hold the
vehicle with only the transmission.
.
Do not keep the vehicle in a stationary
position on an uphill grade by using the
“
D
”
position. Use the brake instead.
.
The engine may, on rare occasions,
knock when the vehicle rapidly acceler-
ates or rapidly pulls away from a standstill.
This phenomenon does not indicate a
fault.
.
A slight reduction in output torque may
occur in the models with a 3.0-liter or 2.5-
liter turbo engine before the engine warms
up.
&
Shift lock release
If the selector lever does not move from
the
“
P
”
position with the brake pedal
depressed and the ignition switch in the
“
ON
”
position, perform the following steps:
To override the shift lock:
1. Set the parking brake and stop the
engine.
2. Take out the screwdriver from the tool
bucket.
Starting and operating
7-29
–
CONTINUED
–
7