Subaru 2008 OUTBACK, Руководство пользователя

Страница: 149 / 444

Black plate (152,1)
北 米
Model "A2440BE-B" EDITED: 2007/ 5/ 7
3-30
Instruments and controls
switch. When the ignition switch is
turned ON next time, however, the
complete sequence of the warning
operation resumes. For further details
about canceling the warning operation,
please contact your SUBARU dealer.
If there is no passenger on the front
passenger
’
s seat, the seatbelt warning
device for the front passenger
’
s seat will
be deactivated. The front passenger
’
s
occupant detection system monitors
whether or not there is a passenger on
the front passenger
’
s seat. Observe the
following precautions. Failure to do so
may prevent the device from functioning
correctly or cause the device to fail.
.
Do not install any accessory such as a
table or TV onto the seatback.
.
Do not store a heavy load in the
seatback pocket.
.
Do not allow the rear seat occupant to
place his/her hands or legs on the front
passenger
’
s seatback, or allow him/her to
pull the seatback.
.
Do not use front seats with their back-
ward-forward position and seatback not
being locked into place securely. If any of
them are not locked securely, adjust them
again. For adjusting procedure, refer to
the
“
Manual seat
”
in the front seats section
in chapter 1 in this Owner
’
s Manual.
(Models equipped with manual seats only)
If the seatbelt warning device for the front
passenger
’
s seat does not function cor-
rectly (e.g., it is activated even when the
front passenger
’
s seat is empty or it is
deactivated even when the front passen-
ger has not fastened his/her seatbelt),
take the following actions.
.
Ensure that no article is placed on the
seat other than a child restraint system
and its child occupant.
.
Ensure that there is no article left in the
seatback pocket.
.
Ensure that the backward-forward po-
sition and seatback of front passenger
’
s
seat are locked into place securely by
moving the seat back and forth. (Models
equipped with manual seats only)
If still the seatbelt warning device for front
passenger
’
s seat does not function cor-
rectly after taking relevant corrective ac-
tions described above, immediately con-
tact your SUBARU dealer for an inspec-
tion.
&
SRS airbag system
warning light
When the ignition switch is turned to the
“
ON
”
position, the SRS airbag system
warning light will come on for approxi-
mately 7 seconds and go out. This shows
the SRS frontal airbag and SRS side
airbag and SRS curtain airbag and seat-
belt pretensioners are in normal operation.
WARNING
If the warning light exhibits any of
the following conditions, there may
be a malfunction in the seatbelt
pretensioners and/or SRS airbag
system. Immediately take your vehi-
cle to your nearest SUBARU dealer
to have the system checked. Unless
checked and properly repaired, the
seatbelt pretensioners and/or SRS
airbags will operate improperly (e.g.
SRS airbags may inflate in a very
minor collision or not inflate in a
severe collision), which may in-
crease the risk of injury.
.
Flashing or flickering of the warn-
ing light
.
No illumination of the warning
light when the ignition switch is
first turned to the
“
ON
”
position
.
Continuous illumination of the
warning light
.
Illumination of the warning light
while driving