Subaru 2008 OUTBACK, Руководство пользователя

Страница: 205 / 444

Black plate (210,1)
北 米
Model "A2440BE-B" EDITED: 2007/ 5/ 7
5-14
Audio
!
Channel scan
Press the
“ ”
side of the SEEK/SCAN
button to change the radio to the SCAN
mode. In this mode, the radio scans
through the channel until a station is
found. The radio will stop at the station
for 5 seconds while displaying the channel
number, after which scanning will continue
until the entire channel has been scanned
from the low end to the high end.
Press the
“ ”
side of the button again to
cancel the SCAN mode and to stop on any
displayed channel.
&
Channel preset
!
How to preset channels
1. Press the
“
SAT
”
button to select XM1,
XM2 and XM3 reception.
2. Press the SEEK/SCAN button or the
TUNE TRACK button to select the chan-
nel.
3. Press one of the preset buttons for
more than 1.5 seconds to store the
channel. If the button is pressed for less
than 1.5 seconds, the preceding selection
will remain in memory.
NOTE
If the connection between the radio and
battery is broken for any reason such
as vehicle maintenance or radio re-
moval, all channels stored in the preset
buttons are cleared. If this occurs, it is
necessary to reset the preset buttons.
!
Selecting preset channels
Presetting a channel with a preset button
allows you to select that channel in a
single operation. Up to six XM1, XM2 and
XM3 channels each may be preset.