Subaru 2008 OUTBACK, Руководство пользователя

Страница: 157 / 444

Black plate (160,1)
北 米
Model "A2440BE-B" EDITED: 2007/ 5/ 7
3-38
Instruments and controls
SUBARU dealer as soon as possible.
.
The light does not go out even after the
lapse of several minutes (the engine has
warmed up) after the engine has started.
&
Security indicator light
This indicator light shows the status of the
alarm system. It also indicates operation
of the immobilizer system.
!
Alarm system
It blinks to show the driver the operational
status of the alarm system. For detailed
information, refer to the
“
Alarm system
”
section in chapter 2.
!
Immobilizer system
This light blinks approximately 60 seconds
after the ignition switch is turned from
“
ON
”
position to the
“
Acc
”
or
“
LOCK
”
position or immediately after the key is
pulled out. (Refer to the
“
Door locks
”
section in chapter 2.)
If the indicator light does not flash, it may
indicate that immobilizer system may be
faulty. Contact your nearest SUBARU
dealer immediately.
In the event that an unauthorized key (for
example, an unauthorized duplicate) is
used, the security indicator light comes
on.
&
SPORT mode indicator
light (4-speed AT mod-
els) (if equipped)
This light comes on when the ignition
switch is turned to the
“
ON
”
position and
goes out after the engine has started.
When the selector lever is moved to the
manual gate, the SPORT mode is se-
lected and the indicator light comes on.
(Refer to the
“
Automatic transmission
–
4-
speed
”
section in chapter 7.)
&
Shift-up indicator light
(MT models) (if
equipped)
When the ignition switch is turned to the
“
ON
”
position, the indicator light comes on
for 3 seconds, and then turns off. While
selecting the Intelligent (I) mode of SI-
DRIVE, this indicator light comes on and
informs the upshift timing to the driver for
fuel-efficient driving.
&
S# PREP indicator light
(if equipped)
1) S# PREP indicator light
When the engine is not warmed up
sufficiently, the S# PREP indicator light
turns on. While this indicator light is on,
the SI-DRIVE mode cannot be changed to
the Sport Sharp (S#) mode. For details
about the SI-DRIVE mode, refer to the
“
SI-
DRIVE (Except 2.5-liter non-Turbo mod-
els)
”
section in chapter 7.