Subaru 2008 OUTBACK, Руководство пользователя

Страница: 104 / 444

Black plate (107,1)
北 米
Model "A2440BE-B" EDITED: 2007/ 5/ 7
four transmitter codes into the system. If
you have only one current transmitter,
program it four times. If you have two
current transmitters, program each one
twice. If you have three current transmit-
ters, program two of them once and the
third one twice. This process will leave
only current transmitter codes in the
system
’
s memory.
NOTE
Make sure no one else is operating
their keyless entry system within range
of your vehicle when programming
transmitters. If someone else were to
operate their remote transmitter while
you are programming your transmit-
ters, it is possible that their transmitter
code will be programmed into your
system, allowing them unauthorized
access to your vehicle.
Alarm system
The alarm system helps to protect your
vehicle and valuables from theft. The horn
sounds and the turn signal lights flash if
someone attempts to break into your
vehicle.
The system can be armed and disarmed
with the remote transmitter.
The system does not operate when the
key is inserted into the ignition switch.
Your vehicle
’
s alarm system has been set
for activation at the time of shipment from
the factory. You can set the system for
deactivation yourself or have it done by
your SUBARU dealer.
&
System alarm operation
The alarm system will give the following
alarms when triggered:
.
The vehicle
’
s horn will sound and the
turn signal lights will flash for 30 seconds.
.
If any door (or the rear gate/trunk lid)
remains open after the 30-second period,
the horn will continue to sound for a
maximum of 3 minutes. If the door (or
the rear gate/trunk lid) is closed while the
horn is sounding, the horn will stop
sounding with a delay of up to 30 seconds.
The alarm is triggered by:
.
Opening a door, the rear gate or trunk
lid
.
Physical impact to the vehicle, such as
forced entry (only vehicles with shock
sensors (dealer option))
&
Activating and deactivating
the alarm system
To change the setting of your vehicle
’
s
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system (refer to
“
Disarming the system
”
in this section).
2. Sit in the driver
’
s seat and shut all
doors (and the rear gate if your vehicle is a
Station wagon).
3. Turn the ignition switch to the
“
ON
”
position.
4. Hold down the UNLOCK side of the
driver
’
s power door locking switch, open
the driver
’
s door within the following 1
second, and wait 10 seconds without
releasing the switch. The setting will then
be changed as follows:
If the system was previously activated:
For a vehicle without SI-DRIVE, the
odometer/trip meter screen displays
“
AL
oF
”
, and for a vehicle with SI-DRIVE, the
multi-information display shows
“
Security
Keys and doors
2-15
–
CONTINUED
–
2