Subaru 2008 OUTBACK, Руководство пользователя

Страница: 254 / 444

Black plate (261,1)
北 米
Model "A2440BE-B" EDITED: 2007/ 5/ 7
1. Open the driver
’
s door (the driver
’
s
door must remain opened throughout the
entire process).
2. Insert the key into the vehicle
’
s ignition
switch and turn to the
“
ON
”
position.
3. Locate the small black programming
button behind the fuse box cover, on the
driver
’
s side left under the dashboard
panel.
4. Press and hold the black programming
button for 10 to 15 seconds. The horn will
honk and the parking lights will flash three
times to indicate that the system has
entered programming mode. At this point
you can perform either action (Step 5 or
Step 6).
5. To program a remote transmitter:
press and release the
“ ”
button on each
transmitter. The horn will honk and the
parking lights will flash one time to indicate
a successful transmitter learn each time
the
“ ”
button is pressed. You can
program up to eight transmitters.
6. To toggle the Horn Confirmation chirps
ON/OFF: press and release the brake to
toggle the feature. The horn will chirp and
the parking lights will flash one time to
indicate Confirmation Horn Chirps are
“
OFF
”
. The horn will honk and the parking
lights will flash 2 times to indicate Con-
firmation Horn Chirps are
“
ON
”
. Pressing
the brake pedal repeatedly will toggle the
feature ON or OFF each time.
7. To exit the remote transmitter and
feature programming mode, turn the igni-
tion switch to the
“
LOCK
”
position, remove
the key from the ignition switch and test
operation of the remote transmitter(s) and
horn confirmation feature.
&
System maintenance
!
Changing the remote control bat-
teries
The two 3-volt lithium batteries (model
CR-1220) supplied in your remote control
should last approximately three years,
depending on usage. When the batteries
begin to weaken, you will notice a
decrease in range (distance from the
vehicle that your remote control operates).
Follow the instructions below to change
the remote control batteries.
1. Carefully pry the remote control halves
apart using a small flathead screwdriver.
Starting and operating
7-13
–
CONTINUED
–
7