Stryker FLUID SAFE, Руководство пользователя

Страница: 23 / 222

Initial Use of the Device
15
EN
A
B
(2)
(5)
(4)
(3)
(6)
(8)
(7)
(1)
(9)
Fig. 4-2 Assembly of the balancing unit
Place roller base (7) on a level surface so
that the rollers with the brake are facing
you.
Ð
Attach the cone holder (5) to the base’s rod
with the 4 lateral threaded pins. Please pay
attention that the tips of the threaded pins
fit exactly into the depressions of the base’s
rod and that they are tightly wound.
Ð
A
Place the stand fittings (4) with cone
holders
(5)
with the frontal side (= side in
which the display unit is found) in the
borings
(6)
of the roller base. Position the
stand so that the container holders are
centered between the lateral sides of the
roller bases. The containers may not be in
contact with the roller bases.
Ð
B
Secure the connection between roller
base and stand fittings, center the washer
(8)
from carton 2 underneath the base,
insert the Allen screw
(9)
and lightly
tighten it by hand.
Ð
Two hollow spots are located at the
circumference of the upper end of the short
rod
(3)
. Slide the support plate
(2)
on the
front short rod of the linkage (3) in such a
way that the 2 setscrews in the support
platte (2) sockets are positioned above the
2 hollow spots.
Ð
Use a small Allen wrench and carefully
screw in the setscrews and correct the
position of the support plate while doing so
to ensure that the tips of the setscrews fit
into the hollows of the pole. Once all parts
are properly positioned, firmly tighten the
setscrews.
Ð