Struers Secotom-10, Инструкция по эксплуатации

Страница: 45 / 193

Secotom-10
Instruction Manual
41
Store the dry cut-off wheels in a horizontal position on a plane
surface, preferably under light pressure.
A clean and dry cut-off wheel does not corrode. Therefore clean and
dry the cut-off wheel before it is put away. Use ordinary household
detergents.
A newly dressed cut-off wheel will give an optimum cut. A badly
maintained and dressed cut-off wheel demands a higher cutting
pressure that will result in more frictional heat. The wheel may also
bend and cause a skew cut. A combination of both factors may result
in damage to the cut-off wheel.
It is a fact that a badly dressed cut-off wheel is the most frequent
reason for damage to the wheel.
Cut-off wheels should be dressed as follows:

Check that there is enough coolant in the machine.

Place the dressing stick onto the cutting table and move it
carefully towards the cut-off wheel. Cut about 5 mm into the
dressing stick and be careful not to turn or twist the dressing
stick.

Move the manual cutting table into the top position and engage
the securing rod into the locking position.

Remove the 2 screws securing the shield around the bulb using
a 3 mm Allen key.

Replace the defective bulb with a new 12 V 20 W halogen bulb.
(Do not touch the glass with your fingers)

Secure the shield again with the 2 screws.

Release the securing rod and move the manual cutting table
down again.
Cut-off Wheels
Replacing the Bulb in the
Manual Cutting Table
screws
halogen bulb