Struers Secotom-10, Инструкция по эксплуатации

Страница: 47 / 193

Secotom-10
Instruction Manual
43
Quick Reference

Lift the transparent cover and the cooling fluid nozzles

Insert the stop pin into the hole of the inner flange.

Loosen the flange screw.

Remove the outer flange.

Mount the cut-off wheel and remount the outer flange, with the
machined face towards the inner flange.

Insert the locking pin in the hole in the inner flange.
Gently fasten the flange screw.

Lower the cooling fluid nozzles to their operating positions.

Use the control on the side of the Secotom-10 to raise and lower
cut-off wheel mounting.

Use the joystick on the Control Panel to move the cutting table.

Position the back stop and the Quick-clamping device.

Tighten the nuts to secure.

Place the clamping tool on the cutting table so that the
positioning studs on the underside press against the outer edge
of the table.

Slide the clamping tool backwards and forwards to insert the
securing bolts in the T-slots.

Press the clamping tool sideways so that the positioning studs
are pressed tight against the table.

Hold it in position and tighten the nuts to secure the clamping
tool.
Wheel speed, feed speed and cut length (and the X Position when
using accessories) can be checked/ changed from the CUTTING
SETUP menu.


Use the Arrow buttons

to select the parameter to be
changed and press ENTER

to confirm
.

Mounting the Cut-off Wheel
Adjusting the Height of the
Cut-off Wheel
Positioning the Cutting Table
Quick-clamping Device
Advanced Clamping Tools
Cutting Setup