Struers Secotom-10, Инструкция по эксплуатации

Страница: 10 / 193

Secotom-10
Instruction Manual
6

Lift the transparent cover to an angle of 45
0
-60
0
.

Lift the cooling fluid nozzles to gain access to the cut-off wheel
mounting.

Insert the stop pin into the hole of the inner flange.

Use the fork spanner (17 mm) to loosen the flange screw.

Remove the outer flange.
Mounting the Cut-off Wheel
IMPORTANT
For manual cutting: only diamond or CBN cut-off wheels with a metal body
are allowed. Abrasive SiC or Al
2
O
3
cut-off wheels or saw blades may not be
used when the manual cutting table accessory is fitted to the Secotom-10.
IMPORTANT
The tolerance between the spindle and inner flange is very small which
means that the two surfaces must be absolutely clean.
Never try to squeeze the cut-off wheel on as this may damage the spindle
or the cut-off wheel. If there are any small burrs, remove them with grinding
paper (grit size 1200).
Outer flange
Flange screw
Hole for stop pin