Strautmann Verti-Mix 1251-L, Перевод оригинальной инструкции по эксплуатации, Страница: 87 / 190

Commissioning
Verti-Mix 951-1651, Verti-Mix 951-L, 1251-L, Verti-Mix 1501 D-3101 D 05.16 87
WARNING Risk of being crushed and of impact to people standing between
tractor and machine while the machine is being hitched!
Make sure that people leave the hazardous area between tractor and
machine before approaching the machine.
Present helpers are only allowed to act as a guide next to the tractor
and the machine and to enter the space between the tractor and the
machine after the vehicles have completely stopped.
WARNING Risk of crushing, cuts, being drawn in, becoming entangled and
risk of impact if the machine accidentally loosens from the
tractor!

Observe the maximum admissible tongue loads, towing
capacities and axle loads of the tractor.

Properly use and secure the provided coupling devices of the
tractor and the machine.
WARNING Risk to people due to a failure of the power supply between
tractor and machine, caused by defective supply lines!
Observe the course of the supply lines during hitching. The supply
lines:

must easily give way to any movements during cornering without
any stress, buckling or chafing,

must not chafe against external components.
1. Secure the machine against rolling. Observe the information in the chapter " Secure tractor and
machine against accidental starting and rolling", page 62.
2. Always check the machine for visible defects during hitching. Observe the information in the
chapter "
Operator’s obligation
", page 32.
3. Couple the drawbar. Observe the information in the chapter " Couple drawbar ", page 64.
4. Connect the hydraulic hose pipes. Observe the information in the chapter " Connect hydraulic
hose pipes ", page 75.
5. Connect the brake system. Observe the information in chapters:

Hydraulic service brake, from page 77,

Automatic reverse overrun brake system, from page 79,

Dual-line compressed-air brake system , from page 81 .

Hydraulic service brake system , from page 84 ,
6. Couple the propeller shaft. Observe the information in the chapter "Couple propeller shaft", from
page 70.
7. Insert the Bowden cable control set / the control unit into the holder of the tractor.
8. Connect the electrical supply lines / lighting system.
9. Lift the supporting leg to transport position. Observe the information in chapters:

"Lift mechanical supporting leg to transport position", page 72,

"Lift hydraulic supporting leg to transport position", page 73.
10. Release the parking brake of the machine. Observe the information in the chapter "Parking
brake", page 85.