Strautmann Verti-Mix 1251-L, Перевод оригинальной инструкции по эксплуатации, Страница: 136 / 190

Service and maintenance of machine
136 Verti-Mix 951-1651, Verti-Mix 951-L, 1251-L, Verti-Mix 1501 D-3101 D 05.16
9.6.3 Change oil
Shop work
1. Secure the machine against rolling.
2. Align the machine in horizontal position.
3. Place a drip tray beneath the hydraulic oil
tank:

Capacity approx. 30 litres in case of
on-board hydraulic system for
hydraulic functions,

capacity approx. 60 litres in case of
on-board hydraulic system for blower
drive.
4. Unscrew oil drain plug (3) from the bottom
of the hydraulic oil tank.
5. Wait for the oil to stop draining out of the oil
drain opening.
6. Screw in again and tighten oil drain plug (3)
(use sealant).
7. Replace the filter element (4) if necessary.
8. Fill the required hydraulic oil and the
required oil quantity through the filler neck
(2) into the hydraulic oil tank.
The oil level must be visible at the
inspection glass (1).
Fig. 83
9.7 Replace shear bolts of shear bolt coupling
1. Secure tractor and machine against
accidental starting and rolling, see
information on page 62.
2. Eliminate the cause for the overloading
(e. g. foreign object in mixing container),
see information on page 114.
3. Strip the propeller shaft (1) off the p.t.o.
shaft of the tractor.
4. Open the fitting apertures on the protective
device. Observe the included operating
instructions for the propeller shaft.
5. Remove the residues of the shear bolt (2).
6. Rotate the power train such that the
boreholes of the coupling halves (3) and (4)
face each other.
7. Replace the shear bolts (2) by a bolt M10 x
50 8.8
8. Close the fitting aperture.
9. Couple the propeller shaft.
Fig. 84