Strautmann Verti-Mix 1251-L, Перевод оригинальной инструкции по эксплуатации, Страница: 39 / 190

Safety instructions
Verti-Mix 951-1651, Verti-Mix 951-L, 1251-L, Verti-Mix 1501 D-3101 D 05.16 39
3.5.3 Electrical system

Before carrying out any work on the electrical system, disconnect the minus pole of the battery!

Always cover the plus pole of the battery as required. Risk of explosion in case of accidental
ground!

Only use the specified fuses. When using bigger fuses, the electrical system may be destroyed.
Risk of fire!

Ensure correct order when connecting and disconnecting the battery:

connection: first connect the plus pole, then the minus pole,

disconnection: first disconnect the minus pole, then the plus pole!

Avoid sparking and open fire in the vicinity of the battery! Risk of explosion!
●
The machine can be equipped with electronic components and parts, the functioning of which
may be affected by electromagnetic emissions of other devices. Such interferences may be a
risk to people if the following safety instructions are not observed:
●
In case of a retrofitting of electrical devices or components into the machine and their
connection to the on-board electrical system, the user must check on his own
responsibility whether the retrofitted parts interfere with the vehicle electronics or other
components.
●
Ensure that the retrofitted electrical and electronic components comply with the EMC
directive as amended from time to time and bear the CE symbol!

Never fit the machine with additional work lights without authorisation! The manufacturer will not
assume any liability or warranty for subsequent damage on the electrical system.
3.5.4 Propeller shaft operation

The included operating instructions of the propeller shaft manufacturer shall apply!

Only use the propeller shafts specified by the manufacturer and equipped with the proper
protective devices!

Always transport the propeller shaft in horizontal position, in order to avoid injuries due to the
propeller shaft halves falling apart!

Check the propeller shaft:

protective tube and protective cone of the propeller shaft must be undamaged,

a protective cover must be mounted to the tractor's and to the machine's p.t.o. shaft! The
protective covers must be in proper condition!

Working with the protective devices being damaged is not allowed!

Mounting and dismounting of the propeller shaft is only allowed:

with the p.t.o. shaft switched off,

with the tractor engine turned off,

with the ignition key pulled out,

with the parking brake applied!

Always ensure proper mounting and securing of the propeller shaft!

Secure the propeller shaft guard against rotation by installing the chain/s!

Always mount the wide-angle joint at the pivot point between tractor and machine when using a
wide-angle propeller shaft!

In case of propeller shafts equipped with overload or overrunning clutch, this clutch must always
be mounted at the machine!