Strautmann Aperion 2101, Перевод оригинальной инструкции по эксплуатации

Страница: 158 / 197

Service and maintenance of machine
158 Aperion 2101, Aperion 2401, Aperion 3401 04.18
8.8.4 Adjust stripper
Ensure that the stripper does not fit too closely to the conveyor belt,
as this may cause a deflection of the conveyor belt to one side.
If the conveyor belt bumps against one side in
the rear area of the vehicle, this may be caused
by a misadjustment of the stripper (1) at the end
of the conveyor belt.
For correct adjustment of the stripper,
1.

unscrew the nine screws (2),
2.

push the stripper (1) to the conveyor belt
from below until it closely fits.
After tightening the screws, a minimum gap of 0.2
mm must be noticeable between the stripper and
the conveyor belt.
Fig. 115