Stratus ftServer 2900 Series, Планирование и руководство по установке

Страница: 45 / 148

Ethernet Cables
Communications Line Planning 4-5
For cabling diagrams and detailed information about making the iSCSI connections to
supported ftScalable Storage systems, see one of the following:

ftScalable Storage G3: Getting Started Guide (R687)

Using ftScalable Storage G4 Systems (R789)
Ethernet Cables
In addition to the Ethernet cables listed in this section, you must also plan to provide
network connection points. Consider providing a network connection with Internet
access for each of the VTMs to allow you and, if authorized, the CAC or your authorized
Stratus service representative to access the VTMs' web interface to operate the system
and diagnose problems remotely. If available, this mode of accessing the VTMs is
faster and more reliable than dialup through the ASN modem.
C A U T I O N !
Make sure network cables can be routed out of the way of
foot traffic.
M I S E E N G A R D E !
Vérifier que les câbles réseau peuvent être acheminés en
dehors du passage.
You will need Ethernet cables for the following connections:

From embedded Ethernet ports on the system and Ethernet ports on optional
Ethernet PCIe adapters to network connection points. See
“Planning for Network
Connectivity” on page 1-4 for information about the number and types of
embedded Ethernet ports available on each system.
N O T E S
1. Two Ethernet ports are typically paired and teamed in
software for fault tolerance. Each member of the pair
requires an Ethernet cable.
2. If you will use the embedded 10GbE ports on an
ftServer 4900 or 6900 system, see
“Category-6/Category-6A Cables” on page 4-8 for
additional site-planning information.

From each supported ftScalable Storage RAID controller tray, if present, to a
network connection point, for web management and monitoring of
ftScalable Storage systems