Stratus ftServer 2900 Series, Планирование и руководство по установке

Страница: 106 / 148

Managing Cables
10-4 Stratus ftServer 29x0, 49x0, and 69x0 Systems: Site Planning and Installation Guide (R786)
Managing Cables
When routing cables within the cabinet, keep all power cords as separate as possible
from peripheral and communication cables. For example, route all power cords on one
side of the cabinet and all peripheral and communications cables on the other side of
the cabinet, using the cable management rings on your cabinet to constrain the cords
and cables.
Connecting a Monitor, Mouse, and Keyboard
You can connect a monitor that you supply and the V115 mouse and keyboard supplied
by Stratus.
N O T E S
1. Other keyboards and mice have not been tested and
may not work properly. See
http://stratadoc.stratus.com/genref/refsell/qualified_e
quipment.html
for third-party peripheral equipment
that has been tested with Stratus ftServer systems.
2. For information about monitor and keyboard
requirements, see “Monitor Requirements” on
page 6-5 and “Keyboard Requirements” on page 7-2 ,
respectively.
Connecting a Generic Monitor
1. Connect the USB cable from the mouse to a USB port located on the backplane at
the rear of the system.
2. Connect the USB cable from the keyboard to another of the system’s USB ports.
(number 1 in Figure 10-1 ).
3. Connect the 15-pin D-sub connector on the VGA cable from the monitor to the
system’s VGA port (number 14 in Figure 10-1 ).
4. Connect the VGA cable to the monitor.
Connecting the ftServer System to External Storage Systems
N O T E
ftServer systems support connections to
ftScalable Storage G3 or ftScalable Storage G4 systems,
depending on the operating system and version of
Automated Uptime Layer installed on the ftServer system.