Stihl MS 362 C-Q, Инструкция по эксплуатации

Страница: 12 / 52

MS 362 C-Q
English
10
The felling notch (C) determines the
direction of fall.
STIHL recommends the following
method:
N
Make the horizontal cut – check the
direction of fall with the gunning
sight.
N
Make angle cut at about 45°.
N
Check the felling notch and correct it
if necessary.
Important:
–
Felling notch at a right angle to the
planned direction of fall.
–
As close to the ground as possible.
–
Cut to a depth of about 1/5 to 1/3 of
the trunk diameter.
Sapwood cuts
Sapwood cuts in long-fibered softwood
help prevent sapwood splintering when
the tree falls. Make cuts at both sides of
the trunk at same height as bottom of
felling notch to a depth of about 1/10 of
trunk diameter. On large diameter trees,
cut to no more than width of guide bar.
Do not make sapwood cuts if wood is
diseased.
Felling
Shout a warning before starting the
felling cut.
N
Make the felling cut (D) slightly
higher than bottom of the felling
notch.
–
Cut horizontally.
–
Leave approx. 1/10 of the tree
diameter uncut between the felling
cut and the felling notch. This is the
hinge.
Drive wedges into the felling cut in good
time. Use only wooden, aluminum or
plastic wedges. Never steel, which can
damage the chain and cause kickback.
001BA143 KN
C
C
001BA150 KN 001BA144 KN
D
D