Stihl MS 362 C-Q, Инструкция по эксплуатации

Страница: 34 / 52

MS 362 C-Q
English
32
N
Pull the retainer (1) upwards to the
rear, tilt air filter in direction of rear
handle and lift it away.
N
Always replace damaged filters.
Versions with fleece filter and felt
prefilter
N
Separate the felt prefilter (1) from
the fleece filter (2) and clean – see
below.
Cleaning the air filter
N
Knock the filter out on the palm of
your hand or blow it clear with
compressed air from the inside
outwards.
If filter is caked with dirt:
N
Wash the filter in STIHL special
cleaner (special accessory) or a
clean, non-flammable solution (e.g.
warm soapy water) and then dry.
NOTICE
Do not use a brush to clean the fleece
filter.
The felt element protects the fleece filter
and prolongs its useful life. It should
therefore be replaced at more frequent
intervals than the fleece filter.
Installing the air filter
N
Push the felt prefilter over the fleece
filter and press it home at all four
corners – only versions with fleece
filter and felt prefilter.
N
Engage the tabs (1) in the
recesses (2).
N
Swing the air filter in the direction of
the filter housing and lock with
retainer.
N
Fit the shroud.
Basic information
The carburetor comes from the factory
with a standard setting.
The carburetor has been adjusted for
optimum performance and fuel
efficiency in all operating states.
The adjusting screws on this carburetor
can only be set within narrow limits.
Standard setting
N
Switch off the engine
N
Check the air filter – clean or replace
it if necessary
N
Check the spark arresting screen in
the muffler (present only in some
countries) – clean or replace it if
necessary
N
Turn the high speed screw (H)
counterclockwise as far as possible
(max. 3/4 turn)
N
Carefully turn the low speed
adjusting screw (L) clockwise as far
as possible – then turn it back 1 turn
0001BA006 KN
1
0001BA012 KN
1
2
0001BA007 KN
1
2
Adjusting the Carburetor
L
0001BA027 KN