Stihl MS 362 C-Q, Инструкция по эксплуатации

Страница: 40 / 52

MS 362 C-Q
English
38
N
Use a screwdriver to remove the E-
clip (1)
N
Remove the washer (2)
N
Remove rim sprocket (3)
N
Inspect transport profile on the
clutch drum (4) – if there are also
heavy signs of wear, also replace
the clutch drum
N
Remove clutch drum or spur chain
sprocket (5) including needle
cage (6) from the crankshaft – with
QuickStop Super chain brake, press
throttle trigger lockout beforehand
Install spur chain sprocket / rim sprocket
N
Clean crankshaft stub and needle
cage and lubricate with STIHL
lubricant (special accessory)
N
Slide needle cage onto the
crankshaft stub
N
After refitting, turn the clutch drum
and/or spur chain sprocket approx.
1 full turn so that the carrier for the
oil pump drive engages – with
QuickStop Super chain brake, press
throttle trigger lockout beforehand
N
Refit the rim sprocket – cavities
toward the outside
N
Refit washer and E-clip on the
crankshaft
Sawing effortlessly with a properly
sharpened saw chain
A properly sharpened saw chain cuts
through wood effortlessly even with very
little pushing.
Never use a dull or damaged saw chain
– this leads to increased physical strain,
increased vibration load, unsatisfactory
cutting results and increased wear.
N
Clean the saw chain
N
Check the saw chain for cracks and
damaged rivets
N
Replace damaged or worn chain
components and adapt these parts
to the remaining parts in terms of
shape and level of wear – rework
accordingly
Carbide-tipped (Duro) saw chains are
especially wear-resistant. For an optimal
sharpening result, STIHL recommends
STIHL servicing dealers.
WARNING
Compliance with the angles and
dimensions listed below is absolutely
necessary. An improperly sharpened
saw chain – especially depth gauges
that are too low – can lead to increased
kickback tendency of the chain saw –
risk of injury!
001BA122 KN
1
2
4
5
6
1
2
3
6
Maintaining and Sharpening
the Saw Chain