Stephill SSD6000W2, Руководство по эксплуатации

Страница: 21 / 36

SSD6000W2
20
Battery Not Charging
Service ● Oil change and oil filter clean recommended.
Canopy Obstructions
● Has the engine overheated? - Check the
generator canopy has no obstructions over any
vented areas - Also see
Operating
Environment in this handbook.
Fault occurs after
the engine has
fired
Fault occurs after
the engine has
fired
Temperature Switch
● Check the temperature switch operation -
Disconnect both wires and link together to test
- replace if necessary -
DO NOT USE WITHOUT
A TEMPERATURE SWITCH FITTED .
High Engine
Temperature
Faulty Wiring
● Check associated wiring from the
temperature switch to the DSE 3110.
Charge Fail
Shutdown
High AC Voltage
Oil Pressure Switch
● Check the oil pressure switch operation -
Switch normally closed when engine is at rest
and open when engine running - Remove,
clean or replace if necessary.
The no-load frequency/rpm should measure approximately 52.5Hz/3150rpm
Low AC Voltage and Low Hz/Frequency could indicate the engine is running too fast.
Warning - It is not recommended to adjust the engine speed unless absolutely
necessary.
High
Hz/Frequency
Faulty Wiring
● Check associated wiring from the oil pressure
switch to the DSE 3110.
Service ● Oil change and oil filter clean recommended.
Low Oil Level
● Check oil level and top-up to the correct level
if necessary.
Oil Pressure Switch
● Check the oil pressure switch operation -
Switch normally closed when engine is at rest
and open when engine running - Remove,
clean or replace if necessary.
Shutdown
The DSE 3110 is displaying the correct no-load frequency (approx. 52.5Hz ) but the
generator shuts down with the High AC Voltage shutdown icon is displayed only.
Faulty Wiring
● Check associated wiring from the oil pressure
switch to the DSE 3110.
Fail To Stop
Low Oil Pressure
Fault Icon Possible Cause Check
Capacitor
● Check the correct size capacitor is fitted to
the AC alternator.
See BATTERY CHARGE SYSTEM - FAULT FINDING