Stephill SSD6000W2, Руководство по эксплуатации

Страница: 16 / 36

SSD6000W2
15
Panel No.7 Only
Undo the fixing bolts that hold the control panel into position.
Drop the control panel forward to gain access to the back.
The remote/auto push-on connectors can be found at one end.
Fig.11
Once the generator has started it will continue to run while the start signal remains closed.
To stop the generator "open" the start signal. The generator will stop and the DSE 3110 will turn off.
When a remote start signal is made (closed) to the generator the DSE 3110 control module display will light-
up and the generator will automatically begin the starting procedure.
A red LED light will be illuminated above the button will indicate that DSE 3110 module in currently
operating in "AUTO" mode.
Automatic Stop Operation
DSE 3110 - Remote Start/Stop
To use this function the generator must be switched to "AUTO" using the toggle switch located on the
control panel. The DSE 3110 module will remain in a
sleep mode (display screen not illuminated) until a
remote start request is made.
Behind the control panel there is a small push-on connector block for the remote and auto start/stop
connections -
Fig.11 . Refer to the DC wiring diagram in this handbook for the relative terminal positions.
Automatic Start Operation
The DSE 3110 control module has an AUTO feature that allows a 2-wire remote Start/Stop function. A
remote module or a on-demand switch can be used to operate this function.
This is the primary method to operate the SSD6000W2 range of generators. The DSE 3110 module will
remain in a sleep mode (display screen not illuminated) until a remote start request is made.
2-Wire Remote Start/Stop Connection Location (Panel No.7 Only)
Once the connections have been made the generator will be ready to receive
a remote start request.